On Thu, 2011-02-17 at 07:26 -0800, Doug wrote: > I have a new PMDX Gecko driver board. It requires an osculating +5 to 0 to > enable the outputs. I am using the step wizard and find that I only get a > solid voltage out of pin 17 when I choose charge pump in the wizard. How > can I fix this? PMDX manufacture does not have a sample config file.
There might be something useful here: http://wiki.linuxcnc.org/emcinfo.pl?About_Charge_Pumps Basically, check to see if the charge pump component is loaded with loadrt, invoked by addf, and connected with net in your .hal file. -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/index.html California, USA ------------------------------------------------------------------------------ The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: Pinpoint memory and threading errors before they happen. Find and fix more than 250 security defects in the development cycle. Locate bottlenecks in serial and parallel code that limit performance. http://p.sf.net/sfu/intel-dev2devfeb _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
