Dear EMC users,
I was asked to make the following change in the controller behaviour.
As you know when we want to stop the running program and we push the stop
program button, program stops and
so does spindle from turning. Now the request is: when we stop the program
by pressing the stop program button, we want the spindle to keep on turning
if it was turning before pressing the
stop program button. What do you think? This is because they do not want the
tool in spindle to get stuck in the workpiece when we stop the program. We
stop spindle by pressing spindle
off button or by entering M5 in MDI later. Thanks
Farzin
------------------------------------------------------------------------------
The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE:
Pinpoint memory and threading errors before they happen.
Find and fix more than 250 security defects in the development cycle.
Locate bottlenecks in serial and parallel code that limit performance.
http://p.sf.net/sfu/intel-dev2devfeb
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
