On 12/9/2010 6:40 AM, Mark Wendt wrote: > Dave, > > When you say you are testing the X axis, are you testing it within > the stepconf program, or with one of the GUI's up and running? > > Mark > > On 12/09/2010 06:29 AM, Dave Christman wrote: >> I am trying to configure and test a 3 axis, 4 drive , machine using a >> Gecko G540 stepper drive. I configure the machine for XYZ axis >> configuration and slave the A and X pins (X step on pins 2 and 8, and X >> direction on pins 3 and 9). When I test the X axis only one motor >> operates. I know the other driver and motor are OK since they work using >> an XYZA configuration and not slaving the drives >> Thanks. >> >> ------------------------------------------------------------------------------ >> This SF Dev2Dev email is sponsored by: >> >> WikiLeaks The End of the Free Internet >> http://p.sf.net/sfu/therealnews-com >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> >> > ------------------------------------------------------------------------------ > This SF Dev2Dev email is sponsored by: > > WikiLeaks The End of the Free Internet > http://p.sf.net/sfu/therealnews-com > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > Within Stepconfig.
------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
