Dave,
When you say you are testing the X axis, are you testing it within
the stepconf program, or with one of the GUI's up and running?
Mark
On 12/09/2010 06:29 AM, Dave Christman wrote:
> I am trying to configure and test a 3 axis, 4 drive , machine using a
> Gecko G540 stepper drive. I configure the machine for XYZ axis
> configuration and slave the A and X pins (X step on pins 2 and 8, and X
> direction on pins 3 and 9). When I test the X axis only one motor
> operates. I know the other driver and motor are OK since they work using
> an XYZA configuration and not slaving the drives
> Thanks.
>
> ------------------------------------------------------------------------------
> This SF Dev2Dev email is sponsored by:
>
> WikiLeaks The End of the Free Internet
> http://p.sf.net/sfu/therealnews-com
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
>
------------------------------------------------------------------------------
This SF Dev2Dev email is sponsored by:
WikiLeaks The End of the Free Internet
http://p.sf.net/sfu/therealnews-com
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
