Am 07.09.2010 04:28, schrieb [email protected]: > Hi > i got problem after i removed system from one machine and install on > another. i maybe wire something wrong. > i want to ask 2 things: > 1. on one axis when i jog, on monitor it show that axis move but motor by > them self didn't move at all. what this mean? > from your motor description I assume a servo system: check your motion controller in the cabinet if it shows an error (led or display) some controllers work with step/diretction signals and mimic stepper systems. You may check them,too but you need an oscilloscope or something like it some controllers have leds for motion input. does the motor make sounds ? you can measure the motor voltage on all 3 phases when running but be careful, read the manuals on how high it may be.
> 2. i used tester and check resistance OM between U-V-W wire from motor > (nema 34 servodynamis AC servo) and it show that that they link. is motor > bad? > maybe not: on a servo motor with 3 phase it is normal. Check if all permutations show the same resistance (usuallly as low as 100 ohm) and the resistance to the ground / housing signal should be more then 1Mohm > thanks > aram > some further questions Has the machine glass scales? what control manufacturer? bye Ulf ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
