Aram, You need to make sure your configuration is sending the signal to the motor. To confirm if the motor works you should move the motor back to the machine where you know it worked. If it works on the old machine then the problem is in the setup on the new machine. thanks Stuart
On Mon, Sep 6, 2010 at 9:28 PM, <[email protected]> wrote: > Hi > i got problem after i removed system from one machine and install on > another. i maybe wire something wrong. > i want to ask 2 things: > 1. on one axis when i jog, on monitor it show that axis move but motor by > them self didn't move at all. what this mean? > 2. i used tester and check resistance OM between U-V-W wire from motor > (nema 34 servodynamis AC servo) and it show that that they link. is motor > bad? > > thanks > aram > > > > ------------------------------------------------------------------------------ > This SF.net Dev2Dev email is sponsored by: > > Show off your parallel programming skills. > Enter the Intel(R) Threading Challenge 2010. > http://p.sf.net/sfu/intel-thread-sfd > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- dos centavos ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
