4 axis foam cutter http://www.vimeo.com/12845451 sory to video format.
But wire streched by spring so You can run 4 axis to spring tolerance. G02 and G03 converted small G01 by other software.This software writen V.S. c# and you can convert Catia 3 axis post to 4 axis foam cutter. 2007/9/13 Ryan Hulsker <[email protected]> > On Thu, 2007-09-13 at 10:16 -0400, John Kasunich wrote: > > Klemen Dovrtel wrote: > > > Hello, > > > > > > I also have a 4 axis hot wire cnc machine, and i have > > > the same problem as Ryan. I successfully set the > > > machine to xyza axes and it works fine, but I would > > > rudder have the correct setup xyuv. I set the .ini > > > files as described here, but i still get some errors. > > > > > > What version/release of EMC Ryan had? There was a > > > discussion at emc mirc channel, that emc release 1.7 > > > doesn't support xyuv setup and emc release 2.x (which > > > can be downloaded from cvs) will. > > > > Close. > > > > The current release is "2.1.7", which does not have UVW. > > The latest version in CVS is "pre-2.2.0", which does have UVW. > > The next release will be "2.2.0", and will have UVW. > > Yes, once I checked pre-2.2 out of CVS I managed to get it working > pretty quickly. You will get an error message when Axis starts up > because the default .ngc file it loads uses xyz, and you will not have a > z axis, but that is not really a significant issue. > > My config files for the foam cutter are attached. I am using a HobbyCNC > stepper driver, and the config files are set up for mm with my 200 > step/rev steppers driving 18tpi threaded rod. > > Ryan > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > -- Eyüp FINDIKLI Makine Mühendisi ------------------------------------------------------------------------------ ThinkGeek and WIRED's GeekDad team up for the Ultimate GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the lucky parental unit. See the prize list and enter to win: http://p.sf.net/sfu/thinkgeek-promo _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
