I merely meant to point out that "commercially you can't feed hold in canned cycles" would be too generalized, since it works for *some*
I wouldn't want an option to start/pause/anything mid cycle on a G76 ;) On Tue, May 18, 2010 at 5:50 AM, Andy Pugh <[email protected]> wrote: > On 18 May 2010 11:12, Daniel Goller <[email protected]> wrote: > >> Just checking, since Fanuc does allow feed hold in canned cycles as >> well, > > I can see that it is easier in some canned cycles than others. Pause > in the middle of G76 lathe threading seems unlikely to work if stopped > mid-cut. You might get away with it (in theory if not in practice) if > you pause on the return move. > > -- > atp > > ------------------------------------------------------------------------------ > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
