In that case shouldn't a pause - stop - jog/mdi/touchoff - manually jog close to previous position - run from here work?
I ran a bunch of cam generated code last night on a simulator setup and could not make the "run from here" (right click on gcode line etc) screw up - although I guess it gets confused on some modal changes according to others. Dave On 5/17/2010 5:07 PM, Steve Blackmore wrote: > On Mon, 17 May 2010 06:44:12 -0700, you wrote: > > >> Re-starting from the beginning of the line of g-code that was PAUSED >> would work for most applications. Consider this as a possible and >> useful partial solution. >> >> This still might be messy with loops and other complications like >> coolant pump state but could prove easier to program. >> >> What would be the problems with cutting some air as part of >> restarting?? There probably are problems in some applications and some >> of these problems might also apply to starting mid-move. Comment from >> people who know more about machining than I do? >> > Commercially Feed Hold doesn't work within loops or canned cycles. > > Stopping at the end of the current line isn't a problem generally and > certainly better than nothing. > > Steve Blackmore > -- > > ------------------------------------------------------------------------------ > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
