One of the many problems with Jog under Pause is that a pause can interrupt a partial move.
Run From Here can get you back to the beginning of the interrupted move. How hard would it be to have EMC figure out how to break the interrupted move into two pieces so that it could bring you back to the splice point? Could this be successfully managed even if the interrupted move was in a subroutine? If it could be done, it should be a way to allow tool offsets to be altered during the pause. Regards, Steve Stallings > -----Original Message----- > From: Kenneth Lerman [mailto:[email protected]] > Sent: Monday, May 17, 2010 7:39 AM > To: [email protected] > Subject: Re: [Emc-users] Jog under PAUSE / tool cnange > > > I've taken the liberty of memorializing John's post (without > what he refers to as a rant that may be removed) at: > http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?WhyManualWhilePausedIsHard > > I've also added a link to it from the page: > http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?ManualWhilePaused > > [I've assumed that is OK with John -- if not, please delete it.] > > Regards, > > Ken > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
