Thanks Chris and Kirk. EMC will load on my desktop with the change. Now I'm headed out to the shop to see if I can make this work in the real world.
Thanks again. Dean -----Original Message----- From: Kirk Wallace [mailto:[email protected]] Sent: Wednesday, April 01, 2009 11:43 AM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] Need Help With Classicladder On Tue, 2009-03-31 at 22:04 -0400, Dean wrote: > Kirk: > That statement was already in my .hal file. But, I did comment out the > 'motion.motion-inpos' line in the postgui.hal file and that did allow EMC to > run. Thanks for the suggestion and I'll keep plugging away. > > Dean >From Jeff's message: " I made a note about this incompatible change on the wiki: http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?UPDATING " It looks like all you need to do is change: "net in_pos motion.motion-inpos => classicladder.o.in-02" to "net in_pos motion.motion-inposition => classicladder.o.in-02" When I looked at the Motion page I didn't bother to read that motion.in-position has the same function as motion.in-pos, which has apparently been deleted. ------------------- Kirk http://www.wallacecompany.com/machine_shop/ ---------------------------------------------------------------------------- -- _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
