On Jan 23, 2009, at 7:27 PM, Glenn R. Edwards wrote: > Hi Dave, > > Here's one from Galil, a pretty trusted supplier of motion > systems. Of > course, using one of these usually leads you to a motor the vendor > recommends, but you can look at the specs and then buy one similar > from > anyone. > > http://www.galilmc.com/learning/motorsizer.php > > Glenn
Thanks Glenn. Apparently that part of their site is down since I get no response on either a linux system or a Mac. Will try later and see if they get it fixed. :-) Dave > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Dave > Engvall > Sent: Friday, January 23, 2009 3:57 PM > To: Enhanced Machine Controller (EMC) > Subject: [Emc-users] matching servo motor to axis > > Hi all, > > Does anyone know of a good worksheet for working thru the design > parameters > for a servo drive. > > eg. given: > servo motor of a given torque and speed; gear reduction ball > screw dia and > pitch desired accel and velocity weight of the axis coeff of > friction for > the slides and probably things I've not thought of. > > With a good set of specs it ought to be possible to calculate ... > yes this will work ... or it is beyond > the given parameters. > > TIA > > Dave > > > ---------------------------------------------------------------------- > ------ > -- > This SF.net email is sponsored by: > SourcForge Community > SourceForge wants to tell your story. > http://p.sf.net/sfu/sf-spreadtheword > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > > ---------------------------------------------------------------------- > -------- > This SF.net email is sponsored by: > SourcForge Community > SourceForge wants to tell your story. > http://p.sf.net/sfu/sf-spreadtheword > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
