Just for info, I made a breakout board using 10k ohm resistors and terminals. I used it to hook up an MPG encoder to the parallel port with selector switches for axis selection and increment. I built it for testing but plan to implement it for a control refit.
Dave On Sun, 2008-10-19 at 11:59 -0600, John Thornton wrote: > yes > > The documentation for the parallal port is in the Integrators manual... > > http://www.linuxcnc.org/docview/html//hal_drivers.html#sec:Parport > > If that is what your asking... > > John > > > On 19 Oct 2008 at 10:14, John Harris wrote: > > > > > Hi, > > Does EMC2 still support the use of a single Parallel Port? If so > > where can I find > > documentation on the functions handled by a single port system and how > > this is done? Thanks > > ____________________________________________________________ John > > Harris E-mail: [EMAIL PROTECTED] > > > > > > > > > > ------------------------------------------------------------------------- > This SF.Net email is sponsored by the Moblin Your Move Developer's challenge > Build the coolest Linux based applications with Moblin SDK & win great prizes > Grand prize is a trip for two to an Open Source event anywhere in the world > http://moblin-contest.org/redirect.php?banner_id=100&url=/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
