Hi not far from me i found it http://portland.craigslist.org/clc/tls/735854816.html i think it can be some major component to work with. just some idea thanks aram
> But the reason for milling/turning the wheel is to get roundness and > straightness. If the wheel is rotating in the jig there's no way to > control > if the wheel is for example elliptic (if it's not mounted in its center, > that is). > > 2008/6/29 Ian W. Wright <[EMAIL PROTECTED]>: > >> >>>>>>>>>>>Sven wrote.... >> >> Why not just make a normal Alu frame router? >> Any special constructed machine would be a problem if there are, let >> say, >> 26, 28 and 29 inch wheels in production.>>>>>>>>>>>> >> >> That was just where my idea was going - if the wheel is run on rollers >> on a >> table under a cnc router, the rollers can be maybe a foot long running >> in >> ball raced plummer blocks at each end and that will then cater for a >> wide >> range of different wheel diameters. >> >> -- >> Best wishes, >> >> Ian >> ____________ >> Ian W. Wright >> Sheffield UK >> >> "The difference between theory and practice is much smaller in theory >> than >> in practice..." >> >> >> ------------------------------------------------------------------------- >> Check out the new SourceForge.net Marketplace. >> It's the best place to buy or sell services for >> just about anything Open Source. >> http://sourceforge.net/services/buy/index.php >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > ------------------------------------------------------------------------- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://sourceforge.net/services/buy/index.php_______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
