On Fri, 2008-05-30 at 15:56 +0300, Alex Joni wrote: > well this wouldn't be an OT message if you put up some latency-test numbers, > or descriptions how well it worked with EMC.. > > Regards, > Alex > > ----- Original Message ----- > From: "Hugues Belanger" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Friday, May 30, 2008 2:39 PM > Subject: [Emc-users] Mini-itx Control > > > > Hi All > > > > doing a little advertising > > > > http://barrie.kijiji.ca/c-buy-and-sell-computers-VIA-EPIA-800-Mini-ITX-all-in-one-512M-RAM-Power-supply-W0QQAdIdZ54215130 > >
I have had trouble getting Linux to run on my C3 ITX board, but that was quite a while ago. I would be interested in knowing if anyone has gotten EMC2 or Linux to run on one of these. It would make a nice low power router/gateway or EMC2 remote. -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC/EMC CNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending Craftsman AA 109 restoration Shizuoka ST-N/EMC CNC) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
