I use Kester with the 331 flux. It's a water soluble flux that cleans up easily with warm water. About 6 seconds wash per sq in has produced good results for me. Just let the board dry well before powering up.
Javid ----- Original Message ----- From: "Kirk Wallace" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Thursday, February 28, 2008 5:52 PM Subject: [Emc-users] OT: Soldering DAC Boards >I am getting ready to assemble my DAC boards (SMT, 8-pin SOIC's). Does > anyone have a favorite lead free solder and paste? Thanks. > > -- > Kirk Wallace (California, USA > http://www.wallacecompany.com/machine_shop/ > Hardinge HNC lathe, > Bridgeport mill conversion, doing XY now, > Zubal lathe conversion pending) > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
