Hello experts and gurus!! I need to simulate the performance of a BLS (board level shield) and I am considering using the IEEE Std 2716-2022 IEEE Guide for the Characterization of the Effectiveness of Printed Circuit Board Level Shielding document. This document is however an adaptation of the methods of evaluating gaskets rather than a focused guide on BLS performance.
Question: Does anyone have experience using this Guide as intended for a BLS solution evaluation? Another Question: Would someone guide me to a paper or experiment that shows a decent correlation of a simulated source in a BLS versus actual measurements ? Here's my concern: The problem of how to internally source a signal for simulation and measurement seems deceptively simple. Just put an antenna on the inside of the shield - right? Well, no. My concern is that the addition of the shield compromises the antenna characteristics and so inadvertently this results in better (or worse) results. With eager anticipation and appreciation for your help with this!! -- Charles Grasso Dish Technologies (c) 303-204-2974 (w) 303-706-5467 (h) 303-317-5530 (e ) [email protected] (e2) [email protected] - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at: https://www.mail-archive.com/[email protected]/ Website: https://ewh.ieee.org/soc/pses/ Instructions: https://ewh.ieee.org/soc/pses/list.html (including how to unsubscribe) List rules: https://ewh.ieee.org/soc/pses/listrules.html For help, send mail to the list administrators: Mike Sherman at: [email protected] Rick Linford at: [email protected] For policy questions, send mail to: Jim Bacher: <[email protected]> _________________________________________________ To unsubscribe from the EMC-PSTC list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=EMC-PSTC&A=1
