Hi,
Panruo Wu <p...@mymail.mines.edu> writes:
> Dear list,
>
>
> #+begin_src sh
> for np in {1..32}
> do
> echo $np
> done
> #+end_src
>
> when executing, the output only shows
> {1..32}
> which is clearly not I want..
>
> After some investigation, I found that orgmode
> uses "sh" that cannot understand the for loop above.
>
> My question is, how can I suggest orgmode to use
> "bash" to execute shell script?
>
> I tried :shebang #!/bin/bash but it does not work
I have the following in my config:
--------------------%<--------------------------
I really like org-babel to use zsh
#+begin_src emacs-lisp
(setq org-babel-sh-command "zsh")
#+end_src
--------------------%<--------------------------
It is apparently not possible to set this variable via #+BIND: to only
change this for one code block, at least I did not succeed to do so in
my attempts to do so -- but maybe I just didn't read enough of the
documentation to /get it right/.
I don't know, if zsh||bash instead of sh breaks any assumptions org-mode
makes about the environment in which sh code blocks are executed; up
until now it works like a charm.
Kind regards,
Tom
