Hi Eric,
I went back and looked at this again. The same code block writes a
named results block now, as it should. I must have put Org-mode in an
unstable state earlier. Sorry for the noise.
Tom
On Jan 5, 2011, at 6:20 AM, Eric Schulte wrote:
Hmm,
I think the code has always named results blocks after the code block
when the code block has a name. I would expect your "new" behavior
below to have been the standard behavior since the early days of
babel.
Best -- Eric
"Thomas S. Dye" <t...@tsdye.com> writes:
Aloha all,
In the course of updating an Org-mode file to take account of the new
file output handling for R, I noticed a change in the naming of
results blocks. In the example below, the top #+results: line was
produced with the most recent Org-mode from git. The previous
behavior is on the following line.
#+srcname: r-complete-length-histogram-pdf
#+begin_src R :results output graphics :file r/adze_len_eg.png :var
x=whole-adzes
library(ggplot2)
adze.len <- ggplot(x, aes(length_poll))
adze.len + geom_histogram()
#+end_src
#+results:
[[file:r/adze_len_eg.png]]
#+results: r-complete-length-histogram-pdf
[[file:r/adze_len_eg.png]]
The only change (other than updating Org-mode) was the addition of
graphics to the :results header argument.
All the best,
Tom
_______________________________________________
Emacs-orgmode mailing list
Please use `Reply All' to send replies to the list.
Emacs-orgmode@gnu.org
http://lists.gnu.org/mailman/listinfo/emacs-orgmode
_______________________________________________
Emacs-orgmode mailing list
Please use `Reply All' to send replies to the list.
Emacs-orgmode@gnu.org
http://lists.gnu.org/mailman/listinfo/emacs-orgmode
