Replying to his own message:
I found Eric's reply. Sorry for the noise.
All the best,
Tom
On Oct 31, 2010, at 8:21 PM, Thomas S. Dye wrote:
On Oct 31, 2010, at 7:40 PM, Noorul Islam K M wrote:
"Thomas S. Dye" <t...@tsdye.com> writes:
Aloha all,
I'm expecting to see the file bar.pdf output.
#+srcname: single-date
#+begin_src R :results output :file foo.pdf
library(ggplot2)
z <- read.csv(file = x)
g <- ggplot(z, aes(x=1950 + cal.BP, y=Posterior.probability))
g + geom_bar(stat='identity') + xlab("Year AD") +
ylab("Probability")
#+end_src
#+call: single-date(x="alpha-2.csv") :file bar.pdf :height 4
#+results: single-date(x="alpha-2.csv")
[[file:foo.pdf]]
Also, the :height header argument doesn't have any effect.
I want the single-date source block to be a general function that I
can call several times from an Org-mode file that I hope to
distribute
as a piece of reproducible research. There will be separate #+calls
for each of the graphs in the paper.
Apologies in advance if the answer is obvious. I'm using Org-mode
version 7.02trans (release_7.02.37.g52fb)
I think there was similar discussion already in this list.
Take a look at
http://www.mail-archive.com/emacs-orgmode@gnu.org/msg32516.html
Thanks and Regards
Noorul
Aloha Noorul,
There is a similar question, but no answer that I can find. Did you
see an answer there?
All the best,
Tom
_______________________________________________
Emacs-orgmode mailing list
Please use `Reply All' to send replies to the list.
Emacs-orgmode@gnu.org
http://lists.gnu.org/mailman/listinfo/emacs-orgmode
