I would be interested in both boards and a kit. 73, Randy, KS4L
On Jun 6, 2010, at 7:40 PM, NQ3RP <[email protected]> wrote: > > I've tried to find one of EA3BLQ's interface cards for the K2 but > have not > been successful. So I thought I would design a replacement since > I've done > PCB designs before. The problem is that if I do it, to keep the > cost down, > I would have to make a couple of dozen boards. So I wondered if > there was > any interest out there in obtaining one of his boards. My main > interest is > in making the K2DI VIII board on this page > http://www.qsl.net/ea3blq/k2di_pci_tec_ang.htm . If you would like > one > please post a reply here. If I get enough responses I'll see about > doing > the run. If you want the K2DI PCI card also please state that > also. If I > get two dozen the cost should be about $20 per board ($40 for the > two). > If you would like a complete kit state that also. I could do the > kit for > around $49.50 for both boards and the electronic parts. > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/Would-you-be-interested-in-a-K2-PSK31-digital-interface-card-tp5147084p5147084.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
