Chris, Do you think you may have switched to another band and then back again before the split did the "unsplit" thing? The default behavior of the K3 is to undo the split if you switch to another band even if you go back to the original band. To preserve the state of the split per band, set Config->SPLT SV-> YES.
73, Ted, W2ZK Chris M0PSK wrote: > On a small number of occasions recently I've been working (what I believed > to be) split on CW, and been embarassed to find that I've transmitted on the > DX frequency. At first I put this down to senior moments, but now that I > have had the same thing happen on RTTY, I am increasingly (if not totally) > convinced that the K3 has reverted from split to unsplit of its own accord. > Could this be a result of RF in the shack? I would appreciate advice on > where to start troubleshooting. I am running the latest firmware on an > unmodded K3/100 #328 with the KA3T installed. The antennas are dipoles with > a common coax feed. > > 73 Chris, M0PSK > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
