Thanks Ron but I knew this already.
Probably have to write to K3support and ask,
however I´m very surprised nobody could answer
on the reflector.
Jim SM2EKM
----------------------
Ron D'Eau Claire wrote:
Hello Jim:
That pot, along with all the other trimmers in the K3, is adjusted at the
factory. There are specific cautions against touching any of them in the
field; all field adjustments are done in firmware.
If you have a problem with the KPA3, suggest you post a message to
[email protected]. If an adjustment is needed that can be done in the
field, one of the fellows there can give you specifics.
Ron AC7AC
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Jan Erik Holm
Sent: Saturday, January 03, 2009 6:55 AM
To: [email protected]
Subject: [Elecraft] K3 KPA3 bias adjust
I find nothing about it in any manual. R11 on KPA3
I guess. What are the specifications for the bias
adjust?
73 Jim SM2EKM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
