I installed this Harbach kit on two SB-200s I have. It takes very little
time and the peace of mind is worth it. You might as well install the
soft-start and soft-key mods at the same time - they go roughly into the
same place on the underside of the SB-200.
Pictures: http://w7brs.com/sb200
Works fine on my K3.
--
Jeff Wandling DE W7BRS K3 #2105 http://w7brs.com/k3
[EMAIL PROTECTED]
On Sat, 22 Nov 2008, GM4KGK wrote:
Ralph Parker wrote:
I'm just about to connect the KEY OUT to the SB-200 relay.
I hope the little transistor in the K3 can take it!
VE7XF
I can thoroughly recommend Harbach Electronics' SK-201 keying kit for the
SB200.
Easy to fit and doesn't break the bank. Reduces keying requirements to about
a volt at 1.5mA and you can use it with any rig.
http://www.harbachelectronics.com/main/page_products_sb200__sb201.html
I have no connection with the company.
73
Norman - GM4KGK
K3 #1139.
--
View this message in context:
http://n2.nabble.com/K3%3A-Keying-SB-200-tp1565952p1566545.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
