DON'T DO IT! The SB200 applies Minus 140 volts or so to the relay control
jack and the K3 can not control it. You could damage the K3.
Don K7FJ
----- Original Message -----
From: "Ralph Parker" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Saturday, November 22, 2008 17:26
Subject: [Elecraft] K3: Keying SB-200
I'm just about to connect the KEY OUT to the SB-200 relay.
I hope the little transistor in the K3 can take it!
VE7XF
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
