Hello,
yesterday I installed the KRX3 into my K3 s/n 0192.
All went well and after the installation the main rx and the tx seem to work
fine.
However, I just tried calibrating my KRX3's synthesizer.
Initially this goes as expected but suddenly the values on the VFO display
add up very quickly and then I get "E00039" on the VFOA display and VFOB
shows "ERR VC4".
Please advise on which steps to take to remove this error.
Thanks in advance
Glenn ON4WIX
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
