It would be nice to have a LINE OUT setting something like =TX/RX where both the received audio and the transmitted audio were available at a preset (independent of volume control) level. It would be very useful in contests to record both sides of a contact CW or SSB.
73 Stewart G3RXQ On Wed, 30 Jul 2008 11:07:35 -0400, hank k8dd wrote: > Ed ..... > > If you look at http://www.writelog.com/support/wlso2r.pdf it shows how to > set up the mike for SSB contesting. If you ignore the Left Rig and the > W5XD Multi+ keyer and just look at the Right Rig and microphone setup you > will see how to keep the audio from the other ops out of your mike. > > In N1MM configurer you can select the line to mute when playing wav files. > This is also mostly the Mic input. Check > http://pages.cthome.net/n1mm/html/English/BasicFunctions.htm#Rec ording_Wav_files > for recording info. > > I have found that if the MON level is turned up so you can hear yourself, > with MIC + Line in you will get feedback when you activate PTT. I'm > assuming this will not happen if the mike is plugged into the sound card. > > Also, if you want to record both TX and RX audio in the contest you have to > select =PHONES. This will send TX & RX audio to the sound card at a level > controlled by the AF Gain control (NOT Line Out level) and possibly > overdrive your sound card. > > 73 Hank K8DD > > > ----- Original Message ----- > From: "Ed Steeble" <[EMAIL PROTECTED]> > >> I tried to use a K3 in the IOTA contest on SSB but ran into a problem. >> I couldn't figure out how to satisfactory key the K3 with wave >> files from N1MM Logger and also use a Heil Headset. Reading the manual it >> appears that you can have audio input from ONLY the front panel, rear >> panel, OR line in. The wave files were coming via the line in and the >> mike via the Front panel. Did I over look something? >> >> A fellow team member and I considered paralleling the mike and sound >> card input but we didn't want a live mike while wave files were playing. >> The Elecraft web site says that their digital voice recorder (KDVR3) is >> not yet shipping. For now, does this mean that that I have to use my >> MFJ voice keyer (configured for a Kenwood radio) if I want audio files AND >> mike capabilities? >> >> When using a K3, how are others handling SSB contests? >> >> 73, Ed >> K3IXD >> > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
