Question for Lyle or whoever might know...does the K3 DSP
allow for easy adjustment of the tap setting?
There are several ways to get this effect. Altering the tap settings
may be one way.
The K3 initial firmware provides two features that may be used to
achieve a similar effect.
The first is to set the wider bandwidth using the WIDTH control, then
turn on NR (noise reduction). If the band is quiet, this will result in
suppression of noise. When a signal appears, NR essentially builds a
low tap count filter around it, so you get much of the effect you're
referring to. Of course, the narrower the WIDTH setting, the less
effect NR will have.
If the band is crowded, you can use the dual passband feature (sometimes
referred to as focus and context filtering) to emphasize the signal near
the sidetone pitch you prefer while still allowing you to hear - at
reduced gain - nearby frequencies.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
