Build it small, build it tight. I used a hydraulic press to make sure the components were pushed down tight to the board before soldering
... well, maybe not :-) ... But it does pay to keep things as small and tight as reasonably possible so you'll have some space around the board. Mine looked tight but things did fit around with no shorting issues. - Keith N1AS - - K2 5411.ssb.100 - -----Original Message----- From: David Wilburn Either I am missing something or this is just crazy. I have the board made up, put down in place and soldered, but I don't see any way I am going to get any other components in there with out them shorting out. How on earth is this supposed to work? Can I put electrical tape on the back side of this thing or something? _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
