I am unclear on the correct orientation of C13 and C20. The directions
state "this [flattened] side must be oriented towards the flattened side
of the component outline." Unfortunately, the component outlines on my
RF board are symmetrical as far as I can see, with no sign of
flattening. Perhaps the through-hole is completely covering up the flat
part of the outline.
Could someone post the correct orientation without reference to the
outline, e.g. "the flat side of C13 should point toward component XYZ"?
Thanks,
Cathy
N5WVR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
