While experimenting with 15 meters today, I noticed that when
transmitting a CQ at 10 watts, HI CUR would appear intermittently on the
display. I have never seen this on the lower bands (20 meters and down)
where I do 99% of my operating. Turning the power down to 8 watts on 15
meters makes the problem go away.
Any ideas? Do I just have the threshold set too low?
BTW, thanks to those who pointed out, in response to my earlier question
about silence on 20 meters, that the problem was likely just propagation
rather than the unit. They were definitely correct, and I've worked a
lot of 20 meter contacts since then.
Cathy
N5WVR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
