It sounds like a bad connection or arc-over in a connector, cable,
balun, etc. after the KAT500. I had a similar issue that drove me nuts
for weeks until I found a corroded solder connection in a balun at the
feedpoint of an antenna. It does not sound like an RFI issue.
73, Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco
On 12/01/2024 23:46, Paul Ecker wrote:
I am experiencing a new problem for me, with my KAT 500. So far I've
noticed this issue on 30M. I am using a dipole cut only for 30M with an SWR
of 1.2 to 1.3 max SWR across the band. I “trained the tuner” at 20khz
segments on 30M.
Setup is K4D, KAT 500 & KPA 500. Win 10 pc.
Running CW, I can start transmitting and all is fine- my LP100A is showing
1.2 SWR and am getting max power out of the radio. Then all of sudden the
SWR jumps to >9.0. The KAT starts chattering and finds a new match. But if
I start transmitting again – pwr out is only about 10 W at that new match,
and eventually the tuner becomes untuned again. Sometimes, it will then
hold the tune but still only getting abt 9-10w power out. The issue occurs
with KPA500 both on and off.
Does this sound like a KAT 500 problem or maybe an RFI problem.
73 Paul
w2eck
______________________________________________________________
Elecraft mailing list
Home:http://mailman.qth.net/mailman/listinfo/elecraft
Help:http://mailman.qth.net/mmfaq.htm
Post:mailto:Elecraft@mailman.qth.net
This list hosted by:http://www.qsl.net
Please help support this email list:http://www.qsl.net/donate.html
Message delivered tok2vco....@gmail.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
