In Windows Sound Control Panel ... select the Recording tab
then select "microphone (USB Audio CODEC)" - the KIO3B ...
select the Advanced tab and make sure Default Format is
to "2 ch, 16 bit, 48000 Hz (DVD Quality)"
73,
... Joe, W4TV
On 1/6/2024 2:11 AM, ev...@pa2kw.com wrote:
Setup was:
* K3 with SUB-RX and MicroHam MKII
* ANT 1 = TX antenna, RX-ANT (BNC) = Receive antenna.
When using the SUB-RX (I think even in Diversity mode), with JTDX I was able to
“listen” to the Left audio channel which was the SUB-RX (receive antenna)
A while ago I installed the KIO3B board. All seems to work fine but….
Whatever I try to change, I’m not able to “listen” to the SUB-RX with JTDX
anymore.
I do hear both receivers in my headphone Main = Right ear, Sub = Left ear.
Is the Audio Codec signal a MONO channel or is it a setting in the K3 I didn’t
think of?
Any help appreciated.
73, Evert PA2KW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to li...@subich.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
