Cris,
In that case, you have firmware 2.04R which locks the sidetone source at
U8-4.
Is your K2 Serial number below 3000? If so you must do the sidetone
source wiring changes as shown in the KIO2 or KPA100 manual.
If SN3000 or above, you have a problem that needs to be found. Do you
have an oscilloscope to aid in troubleshooting?
73,
Don W3FPR
On 7/26/2020 12:18 PM, Christophe aufacf wrote:
hello sorry for the delay,
I didn't have the time, look at the lack of time
stl regler 030, I press on display I have U8-4 but impossible to switch to U8-25
thank you for your opinion
thank you again for your precious help
73 , Cris F8ACF
Le lun. 20 juil. 2020 à 22:56, Don Wilhelm <[email protected]> a écrit :
Christophe,
You likely do not have the proper sidetone source selected.
Go to the STL menu and set the parameter to about 30 - then tap DISPLAY
to toggle between U6-25 and U8-4. Stop when you hear sidetone and exit
the menu.
73,
Don W3FPR
On 7/20/2020 3:50 PM, Christophe aufacf wrote:
Good morning all ,
I repaired my K2 with Don recently the problem now
I realized that I can handle in Cw but I no longer have at the same
time the sound of the CW of course in emission
the STL 030 menu, whatever the level, nothing changes, any idea?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
