Good one Don. I forgot about that one. HI 73, Mark, WB9CIF
-----Original Message----- From: [email protected] <[email protected]> On Behalf Of Don Wilhelm Sent: Sunday, May 12, 2019 17:22 To: [email protected] Subject: Re: [Elecraft] Lack of receive signal Also check to make sure you have not inadvertently selected the RX ANT - that is also a per band setting. 73, Don W3FPR On 5/12/2019 11:55 AM, Mark Musick wrote: > Jack, > Check the ANT selection. On 40 meters is the ANT selection on ANT2 when it > should be set to ANT1? > > 73, > Mark, WB9CIF > > -----Original Message----- > From: [email protected] > <[email protected]> On Behalf Of Jack Colson > Sent: Sunday, May 12, 2019 15:38 > To: [email protected] > Subject: [Elecraft] Lack of receive signal > > I just noticed that my K3 (s/n 1169) is not hearing signals on 7MHz. actually > are attenuated to the point where they are almost non-existant. I checked > the att and pre amp setting and both seem to have an effect on the background > noise but still no received signal ! I do not have a know weak signal source > (shame on me). I will start checking other bands as well but 40 is shot. > 73 and thank you, > Jack, W3TMZ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
