Also check to make sure you have not inadvertently selected the RX ANT -
that is also a per band setting.
73,
Don W3FPR
On 5/12/2019 11:55 AM, Mark Musick wrote:
Jack,
Check the ANT selection. On 40 meters is the ANT selection on ANT2 when it
should be set to ANT1?
73,
Mark, WB9CIF
-----Original Message-----
From: [email protected] <[email protected]> On
Behalf Of Jack Colson
Sent: Sunday, May 12, 2019 15:38
To: [email protected]
Subject: [Elecraft] Lack of receive signal
I just noticed that my K3 (s/n 1169) is not hearing signals on 7MHz. actually
are attenuated to the point where they are almost non-existant. I checked the
att and pre amp setting and both seem to have an effect on the background noise
but still no received signal ! I do not have a know weak signal source (shame
on me). I will start checking other bands as well but 40 is shot.
73 and thank you,
Jack, W3TMZ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
