Correction as below; Tapping MODE switch on my KX3 with MCU 02.90, most latest firmware, switches mode from SSB -> CW -> FM -> FM, then back to SSB. It does skips AM.
73 de JH3SIF, Keith > 2019/01/14 7:37、Keith Onishi <[email protected]>のメール: > > Hello, > > Tapping MODE switch on my KX3 with MCU 02.90, most latest firmware, switches > mode from SSB -> CW -> FM, then back to SSB. It does skips AM. > I have not switched to AM for long time. I think I was able to select AM by > tapping MODE before. > I went through KX3 Owner’s Manual to look for any configuration to skip any > specific mode, but found none. > Sending “MD5;” from KX3 utility software switches KX3 to AM mode. So MPU is > OK on selecting a mode except switching the mode by MODE switch. > I restored my KX3 configuration backed up almost 6 months ago, but the > symptom is same. Then I reloaded the latest firmware to my KX3, but the same > result. > > Have anyone experienced the similar problem? > Your though on any possible cause are welcome. > > 73 de JH3SIF, Keith > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
