Wow. I am still puzled over this one. Everything under the hood looks good. Sometimes it is easy to get a visual on an obviously blown component, but I see absolutely nothing amiss. Even passes the sniff test! The problem exists even with no microphone or key plugged in. Any of you all K2 gurus have any notions on this? I did try a reset of the K2, but that did not make a difference other than giving me an Info 201 code and resetting my displayed frequency and mode to 7100.00c . Again any help or suggestions appreciated. Thanks Mike for the previous suggestion.
73, Bill Allen - WA5PB -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bill Allen Sent: Thursday, April 20, 2006 8:32 PM To: [email protected] Subject: [Elecraft] K2# 1068 stuck in keydown! Importance: High Hey gang, I seem to have a K2 that is stuck in key down (i.e. xmit). When I turn the radio on all I get is the ELECrAFt message, that relays cycle normal, and then a frequency. No front panel controls work except the power knob and it is obvious that I am transmitting and the finals start heating up. What do I need to check or do???? Any and all help appreciated! Yes, I have turned it off... 73, Bill Allen - WA5PB -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.385 / Virus Database: 268.4.4/319 - Release Date: 4/19/2006 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.1.385 / Virus Database: 268.4.4/319 - Release Date: 4/19/2006 -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.385 / Virus Database: 268.4.4/319 - Release Date: 4/19/2006 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
