Carl,
I just went through a version of that. I had no problem getting
FLDIGI to work with my K3s, but it would not work over N1MM. What I
finally discovered is that I had to go into N1MM's config tab under
hardware and needed to set PTT to on. It makes no sense as I use VOX to
do the same thing and it worked with VOX natively. Until I fixed it, I
had no problem with using MMTTY as my RTTY interface. Now, I can go back
to FLDIGI. There's a bug in there, but I'm not sure whether it's FLDIGI
or N1MM+
73,
Barry
K3NDM
------ Original Message ------
From: "Carl Yaffey1" <[email protected]>
To: "Elecraft Reflector" <[email protected]>
Sent: 3/18/2017 9:12:17 PM
Subject: [Elecraft] Fldigi and K3S
Trying to get Fldigi working with my K3S. Had it working fine with my
K3.
No problem receiving PSK. But clicking T/R doesn’t start up the
transmitter. I’ve tried all sorts of different settings in the rig
control, modem, sound card, etc. No luck.
Any suggestions?
73,
Carl Yaffey K8NU
http://www.carl-yaffey.com
http://www.grassahol.com
http://www.bluesswing.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
