The DSP is limited to a maximum bandwidth of 4000 Hz and a highest
"high cut" frequency of 4200 Hz. However, that 4 KHz (200-4200 Hz)
is more than adequate to cover both JT65 and JT9 sections of the
various digital activity (e.g., dial = 14.076 gives 14.0762-14.080
with no issues).
73,
... Joe, W4TV
On 1/2/2016 4:32 PM, Mike Weir wrote:
Good afternoon all, I have for some time now had the 6 Khz filter installed in
my K3. I was just recently on JT-65 in Data A mode and wanted to use the 6Khz
filter. I was only able to open the width to 4 Khz using the width knob? I
wanted to open it up to 6 khz so I could receive both JT65 and JT9 signals.
Any ideas
Mike VE3WDm
This email has been sent from a virus-free computer protected
by Avast. www.avast.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
