Mike,
The K3 audio is limited by a LPF to 4 kHz.
Early on, the K3 audio was wider, but many complained about a high
frequency "hiss", so the LPF was installed. (See the early K3 archives).
The WIDTH knob also has always been limited to 4 kHz.
The 6 kHz filter was *intended* for AM use, and a 6 kHz IF width will
result in an audio width of 3 kHz, so 4 kHz audio width is sufficient
for that.
You can tune the VFO when switching between JT65-HF and JT9.
73,
Don W3FPR
On 1/2/2016 4:32 PM, Mike Weir wrote:
Good afternoon all, I have for some time now had the 6 Khz filter installed in
my K3. I was just recently on JT-65 in Data A mode and wanted to use the 6Khz
filter. I was only able to open the width to 4 Khz using the width knob? I
wanted to open it up to 6 khz so I could receive both JT65 and JT9 signals.
Any ideas
Mike VE3WDm
This email has been sent from a virus-free computer protected
by Avast. www.avast.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
