Fine tool from Weller - the ESF 120:
http://www.f6blk.net/main_fr.php?page=9
and
http://www.labem.pl/obrazki%20weller/esf120.JPG
Simon Brown
---
http://blog.hb9drv.ch/
----- Original Message -----
From: "Ian Stirling" <[EMAIL PROTECTED]>
On Monday 16 January 2006 03:35, Clint Sprague wrote:
When you install a component on the printed
side of the circuit board, and then you tip the board
over to solder, what are accepted methods to keep the
compenent from falling off?
I use a pencil eraser between the board and workbench
to hold the part in place. I don't like the look of
solder pads where the component leads have been bent.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
