I'm attempting my 1st contruction project in many years... CMOS4 keyer, and I have what is probably a pretty stupid question that maybe others can answer for me here. When you install a component on the printed side of the circuit board, and then you tip the board over to solder, what are accepted methods to keep the compenent from falling off? I've read that you should bend the leads to hold the component onto the board but I was wondering if this is the only acceptable way?
Thanks for you info, 73 - Clint - WS1V __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
