Tom asked:
In order to measure output...
1) Can I (or should I) keep the ATU installed and measure at one of the
ATU's antenna jacks?
2) Can I keep the ATU installed, put the dummy load on the ATU antenna
jack and measure the voltage at the original (non-ATU) antenna jack, from
the outside (this jack would not have a dummy load on it, as the dummy would
be on the ATU jack -- actually the real dummy would be holding the RF probes
..hi). This would avoid opening the K2 to make the measurements.
3) Am I missing anything else? Is there a way to check the voltage from
the outside without opening the cover? How about a "T" splitter at the
jack?
---------------------------------------
Hi Tom:
I make as nice "splitter" with a coaxial T connector to access the RF line
outside the K2.
You can let the ATU tune up into the dummy load or you can bypass it. It
should not make a lot of difference.
The least accurate would be #2, where you are measuring the RF between the
output filters and the ATU.
Ron AC7AC
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
