I have a K2 with the ATU among other options (but not the 100 watt amp) and
I would like to measure my power output at the antenna terminal using a
'scope. The ATU provides two antenna jacks (switchable from the from
panel). The jack which came with the basic K2 and is used if the ATU is not
installed is covered with soft plastic (?) so it is not used.
In order to measure output I have been opening the K2, disconnecting the
ATU, put a 50 ohm dummy load on the original antenna jack and measuring the
Vpp at the jack from inside of the K2. (The dummy load does not allow access
to the 'hot' part of the jack from the outside of the rig)
My questions are:
1) Can I (or should I) keep the ATU installed and measure at one of the
ATU's antenna jacks?
2) Can I keep the ATU installed, put the dummy load on the ATU antenna
jack and measure the voltage at the original (non-ATU) antenna jack, from
the outside (this jack would not have a dummy load on it, as the dummy would
be on the ATU jack -- actually the real dummy would be holding the RF probes
..hi). This would avoid opening the K2 to make the measurements.
3) Am I missing anything else? Is there a way to check the voltage from
the outside without opening the cover? How about a "T" splitter at the
jack?
Thanks for your help.
Tom, WB2QDG
K2 1103
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
