I think I missed something. I thought the P3 is IF only How does it receive more than 200Khz around it's passband?
jim ab3cv On Wed, May 1, 2013 at 2:19 PM, Eric Swartz - WA6HHQ, Elecraft < [email protected]> wrote: > IMPORTANT - If you do this, make sure to protect the P3 IF input with > back to back diodes. Static electricity on the whip antenna can harm the > input pre-amp. (Ask me how I know..) > > I made an adapter here with a male-female BNC terminator with the back to > back diodes internally instead of the 50 ohm resistor. > > I power the P3 with a 10 cell AA alkaline battery pack to search for RFI. > > 73, > > Eric > elecraft.com > > On 5/1/2013 10:10 AM, Merv Schweigert wrote: > >> Use your P3, put an antenna on the IF port and it will receive signals >> on the >> freq that you see the interference, power it off a small battery and walk >> around or use a directional antenna to pinpoint the location of the >> interference, >> P3 will tune the band needed. >> One of the uses for the P3 that is overlooked, >> Merv K9FD/KH6 >> >> > ______________________________**______________________________**__ > Elecraft mailing list > Home: > http://mailman.qth.net/**mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> > Help: http://mailman.qth.net/mmfaq.**htm<http://mailman.qth.net/mmfaq.htm> > Post: mailto:[email protected].**net <[email protected]> > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
