Depends on the version ... some pots are mounted vertically, some flat, some have holes in the board to adjust through, etc.
My preference is the RS-35A ... the non-metered version. I find the metering not that accurate. Since the supplies are mounted below the bench and I usually get the DVM when setting them up, I don't see a justification for the added expense <G>. 73, ... Joe, W4TV On 4/16/2013 10:37 AM, Richard Fjeld wrote:
I haven't pulled the cover on my RS-35M yet. Does it have adequate clearance to get to the pot, or did you have to improvise? Rich, n0ce ----- Original Message ----- From: Mike Reublin To: Tom Branton Cc: [email protected] Sent: Tuesday, April 16, 2013 9:05 AM Subject: Re: [Elecraft] K3 power supply recommendations I've used an Astron RS-35M very happily for years. Had to turn it up a tad for the K3. Tip: The voltage adjustment is on the under side of the board...... 73, Mike NF4L ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
