I don't believe it was this thread the mod asked closed. The thread the mod asked closed was the Heil mic thread. This thread started a bit later.
Steve W1SFR- thanks for asking the question. I was offered the same mic for my K2. 73, Bob AC2FA Sent from my iPhone On Mar 15, 2013, at 10:23, [email protected] wrote: > I thought the list admin requested ending this string ?? > > Bob K3DJC > On Fri, 15 Mar 2013 08:25:57 -0400 Stephen Roberts > <[email protected]> writes: >> There is no "A" anywhere indicated on the microphone or base. Preamp >> is off and switch is on low impedence. When I plug it in I get a >> continuous series if dits and no response from any of the controls >> on the unit. >> >> Steve >> W1SFR >> >> >> Sent from my iPad >> >> On Mar 14, 2013, at 9:44 PM, "Joe Subich, W4TV" <[email protected]> >> wrote: >> >>> >>> With a preamp switch on the base, that is an MC-60A. >>> >>> What position is the slide switch *on the microphone*? That is >> the >>> switch that determines high vs. low impedance. You want it in >> the >>> "Low" (500 Ohm) position for the K2 (and K3). There are two >> switches >>> - the one toward the rear is impedance, the one toward the front >> is >>> ON/OFF (the microphone element is disconnected in the OFF >> position). >>> >>> If your microphone did not come with a manual, you may want to >> download >>> a copy from: <http://homepage.ntlworld.com/wadei/MC-60A.pdf> or >>> <http://www.n6wk.com/kenwood/MC-60A.pdf> >>> >>> 73, >>> >>> ... Joe, W4TV >>> >>> >>> On 3/14/2013 7:15 PM, Mike Flowers wrote: >>>> My MC-60 mic says on the bottom by the switch 'mic amp' in/out. >> There >>>> isn't an 'A' on the Kenwood trim on the front - just MC-60. >> Although it >>>> may be an MC-60A, there is no visible designation as such. >>>> >>>> - 73 de Mike, K6MKF, W6NAG, NCDXC, Conway Reef 2012, K3-P3 >> Addict, Maui >>>> >>>> -----Original Message----- >>>> From: [email protected] >>>> [mailto:[email protected]] On Behalf Of Don >> Wilhelm >>>> Sent: Thursday, March 14, 2013 4:12 PM >>>> To: [email protected] >>>> Subject: Re: [Elecraft] Kenwood Mc-60 mic with K2 >>>> >>>> The MC-60 (not A) schematic that I see on the G4WPW website >> indicates that >>>> the switch changes from low impedance to high impedance. For use >> with the >>>> K3 and other modern transceivers the switch should be in the low >> impedance >>>> position. >>>> From the schematic, I cannot understand an "out" label on the >> switch. >>>> If you have an MC-60A, then "out" would be reasonable referring >> to the >>>> preamp either in or out. >>>> >>>> 73, >>>> Don W3FPR >>>> >>>> On 3/14/2013 6:53 PM, Stephen Roberts wrote: >>>>> It's a MC-60 and the switch is "Out". >>>> >>>> ______________________________________________________________ >>>> Elecraft mailing list >>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>>> Help: http://mailman.qth.net/mmfaq.htm >>>> Post: mailto:[email protected] >>>> >>>> This list hosted by: http://www.qsl.net >>>> Please help support this email list: >> http://www.qsl.net/donate.html >>>> >>>> ______________________________________________________________ >>>> Elecraft mailing list >>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>>> Help: http://mailman.qth.net/mmfaq.htm >>>> Post: mailto:[email protected] >>>> >>>> This list hosted by: http://www.qsl.net >>>> Please help support this email list: >> http://www.qsl.net/donate.html >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:[email protected] >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: >> http://www.qsl.net/donate.html >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
