On a related subject, ff you have a KAT100 (not likely if you are using
a transverter) the Vrfdet line from it takes precedence over the KAT2 or
internal RF detector in the K2 and the power control will make the
output at the KAT100 match the knob setting on the K2. This is a
problem if you have a KAT100 and a non-Elecraft amplifier, so Gary
suggested I not bring Vrfdet into the K2 from the KAT100 and that fixed
it for me, so it reads K2 output power again.
Leigh / WA5ZNU
Don Wilhelm wrote:
Phil,
There is no ALC input to the K2, and normally it is not needed. There
is
ALC internally in the K2 to keep the output level at whatever power is
selected on the POWER knob.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
