Gary,
If other attempts (checking computer, ports, cables, etc.) fail,
contact [email protected] and they can give you a couple of points
to measure in the K3. Should the K3 be the fault, and if you are
capable of SMD IC replacement, then they can send you the RS-232 to
TTL/CMOS converter IC and you can replace it. If you are not capable,
you may be able to exchange the KIO3 board.
73,
Don W3FPR
On 1/19/2013 1:59 PM, Gary Smith wrote:
I just went to run my K3 and discovered it wasn't communicating with
the logging program. I shut off the logging program and started the
K3 Utility and refreshing the port list only gives me ports 1 & 3.
Neither of these ports are communicating with the K3. I've restarted
the computer several times and changed USB ports on the computer with
no change. It was working fine when I turned it off yesterday, any
suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
